![]() If your image resides on a network attached disk, your network interface will require configuration. If you wish to eject a CD, double click on the CD icon. Note that the drive letters presented in the left pane may be different from those that Windows uses. In the case that your images are multi-part images – typical for images stored on a FAT formatted device such as a USB hard disk or on CD/DVD recordable media, locate the last image in the set. ![]() If you have an incremental/ differential set, chose the last image in the set, unless you wish to restore to an earlier point in time. Highlight particular backup image that you want to restore, the contents of which will be revealed in the lower right pane. The backup list shows all backup images in the selected folder and the pane below shows the partitions included in the image. ![]() Possible locations are network attached disks, CDs or DVDs, internal hard disks or those attached via USB or eSata. Navigate to the folder that contains the image to be restored in the left hand pane. Image locationįirst a Macrium image file must be located. It operates as a wizard, guiding you through locating an image, selecting what to restore and where to restore it to. Note, RAID systems and disks attached via USB3 interfaces are not supported in this rescue environment. ![]() If you require more flexible imaging and restore options or your hardware is not supported then use the Windows PE rescue environment. It will only enable your to restore your imaged partitions to exactly the same size and position as they were at the time the image was created. The Linux CD is a compact and efficient rescue environment to restore all Windows operating systems.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |